The University of Southampton
University of Southampton Institutional Repository

A spectroscopic investigation of novel doped glasses for active infrared devices

A spectroscopic investigation of novel doped glasses for active infrared devices
A spectroscopic investigation of novel doped glasses for active infrared devices
A number of novel doped glasses have been studied for their potential as infrared amplifier materials. Optical amplifiers which operate outside of the C-band are likely to form part of future optical telecoms systems. This work is focused on transition metal and rare earth-doped materials which could provide gain in the telecoms S-band. Nickel and Vanadium-doped gallium lanthanum sulphide (GLS) glasses were identified as possible new amplifier materials. Emission was observed at 1200nm from Ni-doped GLS and at 1400nm for V-doped GLS. The FWHM of the emission from V-doped GLS was 450 nm, making it particularly attractive for a broadband optical amplifier. Low temperature emission spectra from V-doped GLS suggest that it is not affected by nonradiative decay to the same extent as Cr-doped GLS. Thulium and erbium-doped tin silicate glass-ceramics produced by the sol-gel method were studied for as potential amplifier materials. The addition of tin oxide to these glasses makes them photosensitive and is shown in this work to increase fluorescence lifetimes. However, the addition of >5% SnO2 causes increased infrared absorption which would outweigh advantages gained by the increased lifetime. Thulium-doped tin silicate glass-ceramics were investigated for the first time, and show a broad fluorescence band at 1470 nm with a FWHM of ~120 nm. The maximum lifetime of the 3F4 level was 37 µs, which is higher than in Tm-doped silica. Y2O3-Al2O3-SiO2 (YAS) glass was investigated as a low phonon silicate host for a thulium-doped fibre amplifier. Raman and FTIR measurements showed that the maximum phonon energy can be reduced by increasing the yttria:alumina ratio and decreasing the silica content. This was confirmed by emission lifetime measurements of the 3F4 level, which showed an increase in lifetime of 20% over the range studied. A Tm-doped YAS fibre was successfully drawn from a glass of the composition 17.4% Y2O3, 22.5% Al2O3 and 60% SiO2. 7.5 m of continuous unclad fibre was fabricated with a diameter of 150-350 µm at a temperature of 1150°C. The minimum loss in the fibre was measured to be 3.6 dB/m at 1360 nm. This material is shown to have good potential for use in S-band fibre amplification.
Aronson, Jonathan Edward
ab9d8867-f647-4cf1-b358-76713a5047d2
Aronson, Jonathan Edward
ab9d8867-f647-4cf1-b358-76713a5047d2
Brocklesby, Bill
c53ca2f6-db65-4e19-ad00-eebeb2e6de67

Aronson, Jonathan Edward (2006) A spectroscopic investigation of novel doped glasses for active infrared devices. University of Southampton, Optoelectronics Research Centre, Doctoral Thesis, 195pp.

Record type: Thesis (Doctoral)

Abstract

A number of novel doped glasses have been studied for their potential as infrared amplifier materials. Optical amplifiers which operate outside of the C-band are likely to form part of future optical telecoms systems. This work is focused on transition metal and rare earth-doped materials which could provide gain in the telecoms S-band. Nickel and Vanadium-doped gallium lanthanum sulphide (GLS) glasses were identified as possible new amplifier materials. Emission was observed at 1200nm from Ni-doped GLS and at 1400nm for V-doped GLS. The FWHM of the emission from V-doped GLS was 450 nm, making it particularly attractive for a broadband optical amplifier. Low temperature emission spectra from V-doped GLS suggest that it is not affected by nonradiative decay to the same extent as Cr-doped GLS. Thulium and erbium-doped tin silicate glass-ceramics produced by the sol-gel method were studied for as potential amplifier materials. The addition of tin oxide to these glasses makes them photosensitive and is shown in this work to increase fluorescence lifetimes. However, the addition of >5% SnO2 causes increased infrared absorption which would outweigh advantages gained by the increased lifetime. Thulium-doped tin silicate glass-ceramics were investigated for the first time, and show a broad fluorescence band at 1470 nm with a FWHM of ~120 nm. The maximum lifetime of the 3F4 level was 37 µs, which is higher than in Tm-doped silica. Y2O3-Al2O3-SiO2 (YAS) glass was investigated as a low phonon silicate host for a thulium-doped fibre amplifier. Raman and FTIR measurements showed that the maximum phonon energy can be reduced by increasing the yttria:alumina ratio and decreasing the silica content. This was confirmed by emission lifetime measurements of the 3F4 level, which showed an increase in lifetime of 20% over the range studied. A Tm-doped YAS fibre was successfully drawn from a glass of the composition 17.4% Y2O3, 22.5% Al2O3 and 60% SiO2. 7.5 m of continuous unclad fibre was fabricated with a diameter of 150-350 µm at a temperature of 1150°C. The minimum loss in the fibre was measured to be 3.6 dB/m at 1360 nm. This material is shown to have good potential for use in S-band fibre amplification.

Text
00349383.pdf - Version of Record
Available under License University of Southampton Thesis Licence.
Download (7MB)

More information

Published date: March 2006
Additional Information: Publication No: 3279. Barcode 00349383
Organisations: University of Southampton, Optoelectronics Research Centre

Identifiers

Local EPrints ID: 42431
URI: http://eprints.soton.ac.uk/id/eprint/42431
PURE UUID: b0ad8dec-1c63-414e-b0fe-9e79ae5c9cd7
ORCID for Bill Brocklesby: ORCID iD orcid.org/0000-0002-2123-6712

Catalogue record

Date deposited: 19 Apr 2007
Last modified: 16 Mar 2024 02:39

Export record

Contributors

Author: Jonathan Edward Aronson
Thesis advisor: Bill Brocklesby ORCID iD

Download statistics

Downloads from ePrints over the past year. Other digital versions may also be available to download e.g. from the publisher's website.

View more statistics

Atom RSS 1.0 RSS 2.0

Contact ePrints Soton: eprints@soton.ac.uk

ePrints Soton supports OAI 2.0 with a base URL of http://eprints.soton.ac.uk/cgi/oai2

This repository has been built using EPrints software, developed at the University of Southampton, but available to everyone to use.

We use cookies to ensure that we give you the best experience on our website. If you continue without changing your settings, we will assume that you are happy to receive cookies on the University of Southampton website.

×