The University of Southampton
University of Southampton Institutional Repository

High-power single-mode fiber amplifiers using multimode fibers

High-power single-mode fiber amplifiers using multimode fibers
High-power single-mode fiber amplifiers using multimode fibers
As the optical power levels extractable from current single-mode (SM) fiber amplifiers are reaching regions where optical nonlinearities become significant, even under cw operation, it is becoming increasingly important to develop methods for reducing these nonlinearities to further boost the amplifier performance. Here we demonstrate a simple new approach, namely the SM excitation of specially designed large-core multimode (MM) fibers. Cladding-pumped Er/Yb amplifier versions of such fibers allow the direct amplification of diffraction-limited optical soliton pulses with peak powers up to 12 kW, about one order of magnitude larger than possible with conventional fiber amplifiers.
Under SM excitation of a MM mode fiber, the amount of power propagating in the fundamental mode as a function of fiber length decreases due to micro-bending-induced mode-coupling. The resulting M2-value as a function of fiber length, as calculated from mode-coupling experiments, in various 50µm-core diameter fibers is shown in Fig. 1. The excitation wave-length was 1.55µm. In this fiber #1 was made by the rod-in-tube technique, whereas fibers #2 and #3 where made using modified chemical-vapor deposition. The low-micro-bending fiber #3 indeed allows to obtain an M2-value <1.2 for fiber lengths up to 10m, allowing for essentially diffraction-limited amplification in cladding-pumped Er/Yb amplifiers, which typically vary in length between 1-10m.
The fundamental mode is launched in these MM fibers with high accuracy by suppressing modal speckle by using broad-bandwidth excitation sources such as ultrashort pulses. As the temporal coherence length of broad-bandwidth sources is very short, temporal interference between the modes and thus the presence of speckle is prevented. The stability of the spatial beam profile was verified by coupling the output of a MM fiber into a SM dummy fiber and measuring the launched signal power as a function of time. The result for both single-frequency (SF) excitation and broad-band excitation of the MM fiber is shown in Fig. 2. The large random power fluctuations due to modal speckle for the case of SF excitation are clearly visible, whereas the power fluctuations for broad-band excitation are about a factor of 5 smaller.
Figure 3 shows the autocorrelation and the spectrum of 340 fs pulses directly amplified to a peak power of 12 kW in a 1.5m length of 30-µm-core diameter cladding-pumped Er/Yb amplifier fiber. The pulses had an energy of 4 nJ and were near-transform-limited with a time-bandwidth-product of 0.29. The autocorrelation is displayed on a logarithmic scale to demonstrate the absence of a pedestal. Secondary autocorrelation peaks due to small residual excitation of higher-order modes are suppressed to better than 0.5%.
Pulses amplified to similar peak powers in such Er/Yb fibers have recently also been frequency-doubled to generate 300 femtosecond pulses with peak powers of 25 kW and a record average power of 300 mW at 780 nm.
In conclusion, we have demonstrated a new technique for greatly expanding the operation limits of fiber lasers. The very large-core, low micro-bending fiber amplifiers discussed here should allow the construction of a new generation of ultrahigh-power fiber laser systems.
1-55752-521-8
IEEE
Fermann, M.E.
7b069725-c906-4b27-9b6d-1034b99b0cf7
Galvanauskas, A.
f70d7ce7-84d1-435e-bae9-623e93881ad6
Harter, D.
367da4aa-ad8f-4ba2-841e-5e7e8dc5c936
Minelly, J.D.
5f4c7b1a-99ee-4746-9e3c-4cb420615c50
Caplen, J.E.
12c9dec4-a337-4c85-a132-0f7444f74567
Fermann, M.E.
7b069725-c906-4b27-9b6d-1034b99b0cf7
Galvanauskas, A.
f70d7ce7-84d1-435e-bae9-623e93881ad6
Harter, D.
367da4aa-ad8f-4ba2-841e-5e7e8dc5c936
Minelly, J.D.
5f4c7b1a-99ee-4746-9e3c-4cb420615c50
Caplen, J.E.
12c9dec4-a337-4c85-a132-0f7444f74567

Fermann, M.E., Galvanauskas, A., Harter, D., Minelly, J.D. and Caplen, J.E. (1998) High-power single-mode fiber amplifiers using multimode fibers. In Optical Fiber Communication Conference and Exhibit (OFC '98). Technical Digest. IEEE.. (doi:10.1109/OFC.1998.657185).

Record type: Conference or Workshop Item (Paper)

Abstract

As the optical power levels extractable from current single-mode (SM) fiber amplifiers are reaching regions where optical nonlinearities become significant, even under cw operation, it is becoming increasingly important to develop methods for reducing these nonlinearities to further boost the amplifier performance. Here we demonstrate a simple new approach, namely the SM excitation of specially designed large-core multimode (MM) fibers. Cladding-pumped Er/Yb amplifier versions of such fibers allow the direct amplification of diffraction-limited optical soliton pulses with peak powers up to 12 kW, about one order of magnitude larger than possible with conventional fiber amplifiers.
Under SM excitation of a MM mode fiber, the amount of power propagating in the fundamental mode as a function of fiber length decreases due to micro-bending-induced mode-coupling. The resulting M2-value as a function of fiber length, as calculated from mode-coupling experiments, in various 50µm-core diameter fibers is shown in Fig. 1. The excitation wave-length was 1.55µm. In this fiber #1 was made by the rod-in-tube technique, whereas fibers #2 and #3 where made using modified chemical-vapor deposition. The low-micro-bending fiber #3 indeed allows to obtain an M2-value <1.2 for fiber lengths up to 10m, allowing for essentially diffraction-limited amplification in cladding-pumped Er/Yb amplifiers, which typically vary in length between 1-10m.
The fundamental mode is launched in these MM fibers with high accuracy by suppressing modal speckle by using broad-bandwidth excitation sources such as ultrashort pulses. As the temporal coherence length of broad-bandwidth sources is very short, temporal interference between the modes and thus the presence of speckle is prevented. The stability of the spatial beam profile was verified by coupling the output of a MM fiber into a SM dummy fiber and measuring the launched signal power as a function of time. The result for both single-frequency (SF) excitation and broad-band excitation of the MM fiber is shown in Fig. 2. The large random power fluctuations due to modal speckle for the case of SF excitation are clearly visible, whereas the power fluctuations for broad-band excitation are about a factor of 5 smaller.
Figure 3 shows the autocorrelation and the spectrum of 340 fs pulses directly amplified to a peak power of 12 kW in a 1.5m length of 30-µm-core diameter cladding-pumped Er/Yb amplifier fiber. The pulses had an energy of 4 nJ and were near-transform-limited with a time-bandwidth-product of 0.29. The autocorrelation is displayed on a logarithmic scale to demonstrate the absence of a pedestal. Secondary autocorrelation peaks due to small residual excitation of higher-order modes are suppressed to better than 0.5%.
Pulses amplified to similar peak powers in such Er/Yb fibers have recently also been frequency-doubled to generate 300 femtosecond pulses with peak powers of 25 kW and a record average power of 300 mW at 780 nm.
In conclusion, we have demonstrated a new technique for greatly expanding the operation limits of fiber lasers. The very large-core, low micro-bending fiber amplifiers discussed here should allow the construction of a new generation of ultrahigh-power fiber laser systems.

Text
1656 - Author's Original
Download (424kB)

More information

Published date: 1998
Venue - Dates: Optical Fiber Communication Conference and Exhibit (OFC '98), San Jose, United States, 1998-02-22 - 1998-02-27

Identifiers

Local EPrints ID: 76636
URI: http://eprints.soton.ac.uk/id/eprint/76636
ISBN: 1-55752-521-8
PURE UUID: a0b6a2ad-1381-4118-a30b-3432de15c635

Catalogue record

Date deposited: 11 Mar 2010
Last modified: 13 Mar 2024 23:27

Export record

Altmetrics

Contributors

Author: M.E. Fermann
Author: A. Galvanauskas
Author: D. Harter
Author: J.D. Minelly
Author: J.E. Caplen

Download statistics

Downloads from ePrints over the past year. Other digital versions may also be available to download e.g. from the publisher's website.

View more statistics

Atom RSS 1.0 RSS 2.0

Contact ePrints Soton: eprints@soton.ac.uk

ePrints Soton supports OAI 2.0 with a base URL of http://eprints.soton.ac.uk/cgi/oai2

This repository has been built using EPrints software, developed at the University of Southampton, but available to everyone to use.

We use cookies to ensure that we give you the best experience on our website. If you continue without changing your settings, we will assume that you are happy to receive cookies on the University of Southampton website.

×